Error code
OBD2 P0080
OBD2P0080
Diagnostic Trouble Code· Standard OBD-II fault code read from the vehicle's onboard diagnostics.
What it means
Exhaust Valve Control Solenoid Circuit High.
Severity
moderateCan drive, but performance issues may occur.
Summary
P0080 indicates an issue with the exhaust valve control solenoid circuit being too high in voltage on bank 1 of the engine.
Symptoms
- Check Engine Light (CEL) illuminated
- Rough idle
- Poor performance
- Reduced fuel economy
Common Causes
- Wiring short to positive, causing excessive voltage
- Damaged wire harness or connector between ECM and solenoid valve
- Open circuit in the exhaust VVT solenoid coil
Diagnosis
- Check connector and harness for damage or corrosion.
- Measure voltage at the solenoid valve to confirm circuit integrity.
- Test resistance across the solenoid valve pins for proper operation.
Fixes
- Repair damaged wiring or replace faulty VVT solenoid valve
FAQ
What does P0080 mean?
P0080 indicates a high voltage issue in the exhaust valve control solenoid circuit on bank 1 of the engine.
How do I diagnose P0080?
Use a multimeter to check for proper voltage and resistance at the VVT solenoid valve, inspect wiring harness for damage, and verify connector integrity.
Not affiliated with OBD2. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.
More OBD2 codes
- P0001Fuel Volume Regulator Control Circuit/Open
- P0002Fuel Volume Regulator Control Circuit Range/Performance
- P0003Fuel Volume Regulator Control Circuit Low
- P0004Fuel Volume Regulator Control Circuit High
- P0005Fuel Shutoff Valve 'A' Control Circuit/Open
- P0006Fuel Shutoff Valve 'A' Control Circuit Low
- P0007Fuel Shutoff Valve 'A' Control Circuit High
- P0008Engine Position System Performance
- P0009Engine Position System Performance
- P0010'A' Camshaft Position Actuator Circuit
- P0011'A' Camshaft Position - Timing Over-Advanced or System Performance
- P0012'A' Camshaft Position - Timing Over-Retarded