Error code
OBD2 P0081
OBD2P0081
Diagnostic Trouble Code· Standard OBD-II fault code read from the vehicle's onboard diagnostics.
What it means
Intake Valve Control Solenoid Circuit.
Severity
moderateCan drive, but performance issues may occur.
Summary
P0081 indicates an issue with the intake valve control solenoid circuit on bank 2 of your V6, V8, or V10 engine.
Symptoms
- Check Engine Light (CEL) illuminated
- Rough idle
- Poor performance
- Poor fuel economy
Common Causes
- Wiring and connector damage due to poor repair practices or rodent damage
- Open circuit in the solenoid coil
Diagnosis
- Check connector and harness for damage
- Test voltage at the solenoid valve while engine is running
- Inspect resistance across solenoid valve pins
Fixes
- Repair or replace damaged wiring and connectors
- Replace faulty VVT solenoid valve
FAQ
What does P0081 mean?
P0081 indicates a malfunction in the intake valve control solenoid circuit on bank 2 of your engine.
How do I diagnose P0081?
Use a multimeter to check voltage and resistance at the VVT solenoid valve, inspect wiring for damage, and verify connector integrity.
Not affiliated with OBD2. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.
More OBD2 codes
- P0001Fuel Volume Regulator Control Circuit/Open
- P0002Fuel Volume Regulator Control Circuit Range/Performance
- P0003Fuel Volume Regulator Control Circuit Low
- P0004Fuel Volume Regulator Control Circuit High
- P0005Fuel Shutoff Valve 'A' Control Circuit/Open
- P0006Fuel Shutoff Valve 'A' Control Circuit Low
- P0007Fuel Shutoff Valve 'A' Control Circuit High
- P0008Engine Position System Performance
- P0009Engine Position System Performance
- P0010'A' Camshaft Position Actuator Circuit
- P0011'A' Camshaft Position - Timing Over-Advanced or System Performance
- P0012'A' Camshaft Position - Timing Over-Retarded