Error code
OBD2 P0894
OBD2P0894
Diagnostic Trouble Code· Standard OBD-II fault code read from the vehicle's onboard diagnostics.
What it means
Transmission Component Slipping.
Severity
severeDriving may be possible but not recommended due to potential damage and safety risks.
Summary
P0894 indicates that a transmission component is slipping, meaning it's rotating slower than expected based on input data from sensors like throttle position and engine speed.
Symptoms
- Stored trouble code
- Illuminated warning light
- Harsh or erratic gear shifts
- Transmission may not shift between certain gears or at all
- Hesitation before shifting into gear
- Increased fuel consumption
- Whining, rumbling, or knocking sounds from the transmission
Common Causes
- Low transmission fluid levels
- Dirty or contaminated transmission fluid
- Use of unsuitable transmission fluid
- Blockages in valve body passages
- Defective shift solenoids
- Internal wiring failures
- Mechanical failure of transmission components
Diagnosis
- Record all fault codes and freeze frame data.
- Check fluid level and condition; repair any leaks.
- Test transmission pressure at all available points.
- Inspect oil pan for excessive wear particles or debris.
- Consider replacing valve body, shift solenoids, or the entire transmission.
Fixes
- Replace faulty components such as shift solenoids or internal wiring; replace valve body if necessary.
- Drain and refill transmission fluid with proper type.
- Replace the entire transmission in severe cases.— High
FAQ
Can I drive my car if P0894 is set?
Driving may be possible but not recommended due to potential damage and safety risks.
What should I do first when diagnosing P0894?
Start by checking the transmission fluid level, condition, and for any leaks. Then test the transmission pressure at all available points.
Not affiliated with OBD2. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.
More OBD2 codes
- P0800Transfer Case Control System (MIL Request)
- P0801Reverse Inhibit Control Circuit
- P0802Transmission Control System MIL Request Circuit/Open
- P08031-4 Upshift (Skip Shift) Solenoid Control Circuit
- P08041-4 Upshift (Skip Shift) Lamp Control Circuit
- P0805Clutch Position Sensor Circuit
- P0806Clutch Position Sensor Circuit Range/Performance
- P0807Clutch Position Sensor Circuit Low
- P0808Clutch Position Sensor Circuit High
- P0809Clutch Position Sensor Circuit Intermittent
- P0810Clutch Position Control Error
- P0811Excessive Clutch Slippage