Error code

OBD2 P2010

OBD2P2010
Diagnostic Trouble Code· Standard OBD-II fault code read from the vehicle's onboard diagnostics.

What it means

Intake Manifold Runner Control Circuit High.

Severity

moderateCan drive, but symptoms may affect performance and comfort.

Summary

Code P2010 indicates a high voltage condition in the intake manifold runner control circuit on bank 1. This issue affects the air control actuator or solenoid.

Symptoms

  • Power loss at low engine speeds
  • Rough, erratic idling or fluctuating idle speed
  • Hesitation and stumbling upon acceleration
  • Hard or no start conditions

Common Causes

  • Burnt, damaged, shorted, disconnected, or corroded wiring and/or connectors
  • Defective actuator stepper motor
  • Vacuum leaks caused by damaged or dislodged vacuum lines/components
  • Defective manifold runner position switch
  • Failed PCM (rare)

Diagnosis

  1. Record all fault codes and freeze frame data.
  2. Inspect wiring and vacuum lines for damage or leaks.
  3. Perform electrical tests on the control circuit if no visible damage is found.
  4. Check the position sensor and actuator function using a hand-held vacuum pump (for vacuum-controlled systems).
  5. Command the flaps to open and close multiple times with a scanner to check for intermittent issues.

Fixes

  • Repair or replace damaged wiring, connectors, or vacuum lines.
  • Replace defective actuator stepper motor or position switch.

FAQ

What does P2010 mean?

P2010 indicates a high voltage condition in the intake manifold runner control circuit on bank 1.

How do I fix P2010?

Fixes include repairing or replacing damaged wiring, connectors, vacuum lines, actuator stepper motor, and position switch.

View source

Not affiliated with OBD2. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.

More OBD2 codes

All OBD2 codes →Search more codes →