Error code
OBD2 P2534
OBD2P2534
Diagnostic Trouble Code· Standard OBD-II fault code read from the vehicle's onboard diagnostics.
What it means
Ignition Switch Run/Start Position Circuit Low.
Severity
moderateCan drive, but may experience issues starting the vehicle or maintaining run/start position.
Summary
P2534 indicates a low voltage issue in the ignition switch's run/start position circuit. This problem is located at the ignition switch.
Common Causes
- Wiring short to ground
- Faulty fuse
- Defective ignition switch
Fixes
FAQ
What should I do if my car has P2534?
Check for any wiring issues, a faulty fuse, or a defective ignition switch. These components are commonly involved in this trouble code.
Not affiliated with OBD2. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.
More OBD2 codes
- P2500Generator Lamp/L-Terminal Circuit Low
- P2501Generator Lamp/L-Terminal Circuit High
- P2502Charging System Voltage
- P2503Charging System Voltage Low
- P2504Charging System Voltage High
- P2505ECM/PCM Power Input Signal
- P2506ECM/PCM Power Input Signal Range/Performance
- P2507ECM/PCM Power Input Signal Low
- P2508ECM/PCM Power Input Signal High
- P2509ECM/PCM Power Input Signal Intermittent
- P2510ECM/PCM Power Relay Sense Circuit Range/Performance
- P2511ECM/PCM Power Relay Sense Circuit Intermittent