Error code
Whirlpool F1E1
WHIRLPOOLF1E1
Error Code· Shown on the appliance's control panel.
What it means
EEPROM Checksum Error.
Per Whirlpool Fault Codes (PartSelect)
Motor or Heater Failure or Connector Problem.
Per Whirlpool & Maytag 27in Front-Load Dryer Service Manual (L-98), p25
How to fix it
- Disconnect power for at least 30 seconds and then reconnect. Allow at least a minute after power has been restored and if error code reappears, replace control board (clock).
Not affiliated with Whirlpool. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.
More Whirlpool codes
- F1E0EEPROM Communication Error
- F1E2UL A/D Error(s)
- F1E3Wiring Harness Cavity Size Does Not Match Stored Value
- F1E4Model ID Error
- F1E5Calibration Shifted
- F1E6Latch Signal Mismatch Error
- F1E9Stack Overflow
- CECommunication Error
- E1Open Thermistor
- E2Shorted Thermistor
- ERProcessor Reset Error
- F0Control Board Failure