Error code
Roper F1E6
ROPERF1E6
Error Code· Shown on the appliance's control panel.
What it means
Latch Signal Mismatch Error.
How to fix it
- Disconnect power for at least 30 seconds and then reconnect. Allow at least a minute after power has been restored and if error code reappears, replace control board (clock).
Not affiliated with Roper. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.
More Roper codes
- F1E0EEPROM Communication Error
- F1E1EEPROM Checksum Error
- F1E2UL A/D Error(s)
- F1E3Wiring Harness Cavity Size Does Not Match Stored Value
- F1E4Model ID Error
- F1E5Calibration Shifted
- F1E9Stack Overflow
- F0Control Board Failure
- F1Control Board Failure
- F2Oven Temperature Is Too High
- F2E0Shorted Touch Pad (Keypad)
- F2E1Touch Pad (Keypad) Cable Unplugged