Error code
Whirlpool F02
WHIRLPOOLF02
Error Code· Shown on the appliance's control panel.
What it means
Long Drain (Drain Exceeds 8 Minutes).
How to fix it
- Select 'cancel' twice to clear error code. Note: You may see a "SUD" error code appear first during this failure. This should change to the F02 error code after a few minutes. Proceed by checking the drain hoses for proper connection and kinks. Unplug unit and disconnect power. Check the electrical connections at the pump and make sure it is operational with no debris or blockage. Reconnect power and plug unit in. If problem has not been corrected, replace the pump.
Not affiliated with Whirlpool. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.
More Whirlpool codes
- CECommunication Error
- E1Open Thermistor
- E2Shorted Thermistor
- ERProcessor Reset Error
- F0Control Board Failure
- F05Water Temperature Sensor Error
- F06Drive Motor Tachometer Error (Unable to Detect Motor Speed)
- F09Overflow Condition (Pressure Switch Closed Too Long)
- F1Control Board Failure
- F10Motor Control Unit (MCU) Heat Kink Thermal Trip (Too Hot)
- F11Serial Communication Error Between MCU and CCU
- F13Dispenser Circuit Error