Error code
Whirlpool F10
WHIRLPOOLF10
Error Code· Shown on the appliance's control panel.
What it means
Motor Control Unit (MCU) Heat Kink Thermal Trip (Too Hot).
How to fix it
- Check for proper installation and ventilation, and make sure unit is not located near a heat source. Disconnect power and unplug the unit to check wire harness connections to the motor, MCU, and Central Control Unit (CCU). Check the drive system for any worn or failed components and reconnect power and plug unit in. Check MCU by looking for operations of the drive motor and check drive motor for powered rotations. Replace failed component.
Not affiliated with Whirlpool. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.
More Whirlpool codes
- CECommunication Error
- E1Open Thermistor
- E2Shorted Thermistor
- ERProcessor Reset Error
- F0Control Board Failure
- F02Long Drain (Drain Exceeds 8 Minutes)
- F05Water Temperature Sensor Error
- F06Drive Motor Tachometer Error (Unable to Detect Motor Speed)
- F09Overflow Condition (Pressure Switch Closed Too Long)
- F1Control Board Failure
- F11Serial Communication Error Between MCU and CCU
- F13Dispenser Circuit Error