Error code
Whirlpool F14
WHIRLPOOLF14
Error Code· Shown on the appliance's control panel.
What it means
EEPROM Error.
How to fix it
- Disconnect power and unplug unit. Verify Central Control Unit (CCU) is operating properly by running a diagnostic test or any cycle. Replace is defective. Note: A power glitch may cause this error. Try unplugging unit for two minutes to see if that fixes error.
Not affiliated with Whirlpool. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.
More Whirlpool codes
- CECommunication Error
- E1Open Thermistor
- E2Shorted Thermistor
- ERProcessor Reset Error
- F0Control Board Failure
- F02Long Drain (Drain Exceeds 8 Minutes)
- F05Water Temperature Sensor Error
- F06Drive Motor Tachometer Error (Unable to Detect Motor Speed)
- F09Overflow Condition (Pressure Switch Closed Too Long)
- F1Control Board Failure
- F10Motor Control Unit (MCU) Heat Kink Thermal Trip (Too Hot)
- F11Serial Communication Error Between MCU and CCU