Error code
Whirlpool FL
WHIRLPOOLFL
Error Code· Shown on the appliance's control panel.
What it means
Flood Condition.
How to fix it
- FL error code will appear when the unit detects an overfill, or excessive amounts of water in tub. When this error occurs, the pump should be cycled in drain mode for 30 seconds on and 30 seconds off until the switch resets. Press 'Stop/Cancel' to clear display.
Not affiliated with Whirlpool. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.
More Whirlpool codes
- CECommunication Error
- E1Open Thermistor
- E2Shorted Thermistor
- ERProcessor Reset Error
- F0Control Board Failure
- F02Long Drain (Drain Exceeds 8 Minutes)
- F05Water Temperature Sensor Error
- F06Drive Motor Tachometer Error (Unable to Detect Motor Speed)
- F09Overflow Condition (Pressure Switch Closed Too Long)
- F1Control Board Failure
- F10Motor Control Unit (MCU) Heat Kink Thermal Trip (Too Hot)
- F11Serial Communication Error Between MCU and CCU