Error code
Whirlpool SL
WHIRLPOOLSL
Error Code· Shown on the appliance's control panel.
What it means
Suds Lock.
How to fix it
- This error will occur if the unit detects suds but is unable to clean them out. The unit will attempt the clean out the suds three times before displaying this error. It can also indicate a bad pump, an extra heavy load, excessive detergent, or excessive suds. Press 'Stop/Cancel' to clear the display.
Not affiliated with Whirlpool. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.
More Whirlpool codes
- CECommunication Error
- E1Open Thermistor
- E2Shorted Thermistor
- ERProcessor Reset Error
- F0Control Board Failure
- F02Long Drain (Drain Exceeds 8 Minutes)
- F05Water Temperature Sensor Error
- F06Drive Motor Tachometer Error (Unable to Detect Motor Speed)
- F09Overflow Condition (Pressure Switch Closed Too Long)
- F1Control Board Failure
- F10Motor Control Unit (MCU) Heat Kink Thermal Trip (Too Hot)
- F11Serial Communication Error Between MCU and CCU