Error code
Whirlpool SR
WHIRLPOOLSR
Error Code· Shown on the appliance's control panel.
What it means
Stuck Relay.
How to fix it
- The machine control board may have a bad relay and may need to be replaced. Check pins 1 and 5 of P16 of the machine controller and pins 1 and 2 of P1 of the motor controller. This should have AC line voltage when the motor controller is powered. Press 'Stop/Cancel' to clear display.
Not affiliated with Whirlpool. Answer summarized from the manufacturer's manual linked above; consult that source for the authoritative procedure.
More Whirlpool codes
- CECommunication Error
- E1Open Thermistor
- E2Shorted Thermistor
- ERProcessor Reset Error
- F0Control Board Failure
- F02Long Drain (Drain Exceeds 8 Minutes)
- F05Water Temperature Sensor Error
- F06Drive Motor Tachometer Error (Unable to Detect Motor Speed)
- F09Overflow Condition (Pressure Switch Closed Too Long)
- F1Control Board Failure
- F10Motor Control Unit (MCU) Heat Kink Thermal Trip (Too Hot)
- F11Serial Communication Error Between MCU and CCU